You are here:   Pumps -> Electric Perfusion Pump

Electric Pump Manual 

The miniature air compressor initially pressurizes a small cylinder to a pre-set high-pressure level in only a few minutes with dry air.  After the compressor shuts off, over two hours of continuous perfusion can be maintained by the system. The compressor automatically turns on to recharge the high-pressure cylinder when pressure drops below a pre-set level.

Available in 115 or 240 volt, 50 or 60 Hz.  Please specify voltage and frequency.

The extra large water chamber, 1.0 litre in capacity, has a built-in filter to prevent clogging of the capillary tubes.  The manual pressure relief valve allows easy pressure adjustment and shut-down.

Our Electric Manometric Perfusion Pumps are compliant with the following electrical standards: CNA/CSA-C22.2 No. 601.1, IEC 601-1, UL Standard No. 2601-1 and EN60601-1-2.

Advantages of the electric model:

• No inconvenience of handling heavy N2 gas cylinder.

• Eliminates the cost of gas and rental charges.

• Eliminates the need of modifying N2 gas cylinder adapter in countries where local gas cylinder sizes are different from North American standard.

March, 2008:

New Authorized Europe Representative

[ more detail ]

November, 2006:

New PVC extrusions and single-use catheters... 

[ more detail ]

November, 2005:

Attention all infusion pump users... 

[ more detail ]

November, 2005:

New AC infusion pump standard for Korea... 

[ more detail ]

June, 2004:

Mui Scientific opens up Dentsleeve International Ltd...  

[ more detail ]

Legal Disclaimer:

The information on this website is for guidance only.  It is provided in good faith as a service to the medical community.  It does not constitute legal or business advice and should not be relied upon as such.  Responding to or acting upon material on this website does not constitute or imply any client/advisor relationship between Mui Scientific and any party, nor can it lead to any liability for Mui Scientific.